The monitor needs to know the time, date, unit cost per kWh charged by your electricity supplier, along with voltage and alarm settings. The following steps will move through each of these settings.
Setting time and date
Press and hold for 2 seconds the TIME SET. button located on the reverse of the monitor. The time setup will flash on the display.
Use the backward and forward buttons to set the hour. Press the mode/set button once to save. Repeat the same process to set the minutes. Once the correct time and date have been set, push the mode/set button to save and move onto the date setup.
Set the month by using the backward and forward buttons. Press the mode/set and move onto the day and year. Repeat the same process and then press the mode/set button to save and exit.
Voltage
Press and hold the mode/set button for 2 seconds. Adjust the voltage using the backward and forward buttons. Push mode/set button to confirm and to move onto currency selection set up.
Currency
There are 5 different world currencies available (£, €, $, Kr, R). Press and hold the mode/set button for 2 seconds. Select the currency using the backward and forward buttons. Default currency will be $. Push mode/set button to confirm and to move onto tariff selection set up.
Tariff period
Select up to 4 different tariff cost settings. You will note that the words TARIFF 1 will appear. The 1 represents the tariff selected. Use the backward and forward buttons to choose between tariff periods, then press the mode/set button to confirm and will move to set tariff pricing.
Tariff pricing
On completing the above, pricing will appear next. Use the backward and forward buttons to increase or decrease the cost and press the mode/set button to confirm. You have now completed your manual tariff programming. Press mode/set button to move onto the set-up for Carbon Emissions Ratio, Alarm, and Temperature.
Carbon emissions ratio
By default the carbon emissions ratio is 0.50 KgCO2. Use the backward and forward buttons to increase or decrease the value and press the mode/set button to confirm. Press mode/set button to move onto the set-up for Alarm.
Maximum power alert
The audio alert will sound if you go over your set maximum power consumption target. Use the backward and forward buttons to increase or decrease the value and press the mode/set button to confirm. Press mode/set button to move onto the set-up for TEMPERATURE.
Temperature
Use the backward and forward buttons to move between different temperature scales (Celsius and Fahrenheit) and press the mode/set button to confirm. You have now completed your Energy Display set up. Press mode/set button to move onto ENERGY NOW.
Multiple tariff
You will only need to use this setting if you have dual or multiple tariffs Press and hold the mode/set button for 2 seconds. Press the mode/set button two more times to find the tariff mode. Use the backward and forward to choose between tariff periods 1, 2, 3 or 4. Press the mode/set button to confirm and will move to set the start and end of the tariff period. Use the backward and forward buttons to set the start time for tariff. Press the mode/set button to set the end of the tariff using the backward and forward buttons again. Press the mode/set button to finish. Repeat this process to configure each tariff period.